This is an important step to ensure that the flooring is centred. You want to avoid having planks that are less than 2 inches wide and again, cutting the floor accordingly. Next, measure the width of the room and divide by the width of the plank. You’ll need to cut your first plank accordingly if the number is less than 8 inches. You want to avoid having planks that are less than 8 inches on opposite ends of the room. Taking the length, divide this number by the length of the planks. Measure the length and width of the room in inches. Step 4: Measure the roomĪs mentioned above, measure the room once, twice, and triple-check for a smooth installation. Be sure to keep these spacers in place during installation. Allow at least two spacers for each plank. Create about a ¼-inch to ⅜-inch gap between the flooring and the walls with floor spacers placed throughout the length of the wall. Step 3: Insert floor spacersįloating vinyl plank flooring expands with temperature changes, so it’s important to leave an expansion gap along the walls. After removing the baseboards, thresholds, and undercutting the doorjambs, remember to run a vacuum once again through the room to make sure the space is thoroughly clean. Using a small scrap of flooring as a guide, take your jamb saw or an oscillating tool to trim door jambs and casings. Start at one end of the baseboard and carefully move along the trim. Using a putty knife to gently wiggle behind the baseboard reduces the chances of damaging the paint on the walls. You can either use a metal putty knife or a pry bar to remove the baseboards and thresholds. Vinyl plank Cochrane Step 2: Remove baseboards and thresholds and undercut doorjambs
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |